APF Inspection Plug, Size: 2-1/2 in, Item Thickness: 5/16 in, Material: Aerogel, Application: For Use When Using Thin Insulation Materials That Produce an Insulation Thickness of Less Than 1 in After Installation, Special Features: APF, Temperature Rating: 33 to 1000 deg F
Application :
For Use When Using Thin Insulation Materials That Produce an Insulation Thickness of Less Than 1 in After Installation
Item Name :
Inspection Plug
Item Thickness :
5/16 in
Material :
Aerogel
Size :
2-1/2 in
Special Features :
APF
Temperature Rating :
33 to 1000 deg F
- Designed for use when using thin insulation materials that produce an insulation thickness of less than 1 in after installation
- No hole saw is not required for installation, this prevents possible damage to the base metal from the hole saw pilot bit or accidental damage to hidden trace lines
- The inspector is shielded from the cut edge of the jacketing by the center draw of the flange, this allows you to comply with OSHA safety requirements
- Silicone applied under the flange is what provides the primary holding and sealing capabilities for the flange to the jacketing surface
- The elasticity of the large volume of silicone under the flange is what helps maintain the airtight and watertight seal during any thermal expansion or contraction of the jacketing material
- When installed per manufactures recommendation, a permanent airtight and watertight seal will be achieved
- 1/2 in banding slots are provided in the flange to allow the inspection port to be banded in place when required
- Based on the application needed, all flat flanges can be field contoured to conform to a smaller radius
- Outer seal is made using a high-temperature O-ring for a weather tight seal
- The metal cup is designed for to provide efficient ambient cooling
Standards/Certifications: OSHA Compliant